Toledo Keyless Manual Del Usuario página 5

5. INSTALL STRIKE
a. Half-close the door to lay the latchbolt against the door frame. Mark
the position of faceplate as an indication. Place the strike against the door
frame and mark it's perimeter. Be sure the center of strike is perfectly
aligned with the center of faceplate.
b. Drill a ø 25.4mm (1") hole with 13mm (1/2") depth on the center of
strike outline. Then use the chisel to scrape out the door frame for 1.6mm
(1/16") deep within your pencil mark. Ensure to chisel deep enough
to allow the strike lay fl ush with the frame surface.
c. Insert the strike and tighten it with screws.
Note: please use "tapping screws" for metal door.
6. INSTALL KEYLESS ASSEMBLY
a. Place the leverset / knobset against keyless pad with tailpiece in vertical
position inserted through cam of the latch.
Tailpiece must be turned
in vertical position
b. Pass the IC wire over the latch to the interior side of door.
3
2
1
8
7
6
IC wire
4
3
2
1
8 9
7
6
Tailpiece
4 5
9
0
Outside Knob
4
3
2
1
8 9
7
6
5
0
Outside Lever
5
0