Toledo Keyless Manual Del Usuario página 9

Specifi cation/Function
1.Power
6V, four AA (1.5V) Alkaline batteries.
2.Low Battery
2-1 The batteries should be changed immediately once you see button 1 fl ashes
in red and hear 10 rapid beep sounds when press programming button.
2-2 All settings are retained in the memory and will not be affected even
if the battery is completely dead.
2-3 The lock still can be operated by key even there is a power outage.
3.llluminated lndicator
3-1 Button 1 fl ashes in green once when successful operation.
3-2 Button 1 fl ashes in green twice when successful programming.
3-3 Button 1 fl ashes in red 3 times when there is an operation error.
3-4 Button 1 fl ashes in red 5 times when codes input error, the system will shut down
for system protection (refer to17).
3-5 Button 1 fl ashes in orange 3 times when system has been restored to default setting.
3-6 Button 1 fl ashes in orange slowly while in programming mode.
4.Audible lndicator
4-1 1 beep sound indicates a successful operation.
4-2 2 long beeps indicate a successful programming
4-3 3 beeps indicate an operation error.
4-4 3 long beeps indicate that system has been restored to default setting.
4-5 5 beeps when codes input error, the system will shut down for system protection.
(refer to 17)
4-6 10 rapid beeps indicate the power of battery is low.
5.Programming Code
5-1 The preset Programming Code is 0000. Please change it into new one when fi rst
time operation.
5-2 Only one set of Programming Code for function setting.
5-3 Programming Code is only for function setting, you can not unlock the lockset
by entering Programming Code.
5-4 Programming Code is 4 to 10 digits in length.
5-5 Programming Code can be changed anytime if needed.