Toledo Keyless Manual Del Usuario página 6

7. INSTALL INSIDE MOUNTING PLATE
Pass th IC wire through the hole
on the mounting plate and hold
the mounting plate with screws.
If outside lock assembly is lopsided,
please loosen the screws to adjust
it's position and tighten the screws
again.
8. INSTALL RECEIVER MODULE
a. Remove the battery cover (push it up and pull it out).
b. Connect the IC wire and ensure the turn piece is horizontal, so that the
tailpiece is able to be engaged with the inside lever / knob. Then attach
receiver module to the door with screws. It is optional to use the attached
wood screw. (wood screws are only for wood door)
a.
Turn
Piece
c. Insert 4(AA) 1.5v alkaline batteries and put the battery cover back to the
receiver module.
c.
Inside
Lever
Battery
cover
Receiver
module
IC Wire
Screws
b.
wood screw
screws
Inside
Knob
Mounting
Plate