Assembly; To Assemble The Guide Bar And Saw Chain - Husqvarna T540i XP Manual Del Usuario

not correctly lubricated, the risk of wear on the guide
bar, saw chain and chain drive sprocket increases.
To assemble the guide bar and saw
chain
WARNING: Always remove the battery
before you assemble or do maintenance on
the product.
1. Disengage the chain brake.
2. Loosen the bar nut. Remove the drive sprocket
cover and the transportation ring (A).
1036 - 003 -

Assembly

A
3. Install the guide bar on the bar bolt.
4. Steer the guide bar to its most rear position. Lift the
saw chain above the drive sprocket and engage it in
the groove on the guide bar. Start on the top edge of
the guide bar.
5. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
6. Install the drive sprocket cover and steer the chain
adjuster pin to the hole in the guide bar.
7. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
8. Make sure that the saw chain is correctly engaged in
the groove in the guide bar.
9. Tighten the bar nut with your fingers.
11