To Do A Check Of The Battery Charger; To Clean The Cooling System; To Do A Check Of The Battery And The Battery Holder; To Sharpen The Saw Chain - Husqvarna T540i XP Manual Del Usuario

2. Make sure that the chain catcher is stable and
attached to the body of the product.
To do a check of the functions of the user
interface
1. Start the product. Refer to
page 14 .
2. Push and hold the start/stop button.
3. Make sure that the product stops and that the green
LED goes off.
To do a check of the battery and the
battery holder
1. Clean the battery and the battery holder with a soft
brush.
2. Clean the cooling slots and battery connectors.
3. Make sure that the battery is not damaged and there
are no other defects, such as cracks.
20
To start the product on

To do a check of the battery charger

1. Make sure that the battery charger and the power
supply cord is not damaged. Look for cracks and
other defects.

To clean the cooling system

The cooling system keeps the engine temperature
down. The cooling system includes the air intake on the
left side of the product and a the fan on the motor.
The cooling system includes an air intake on the left side
of the product and a fan on the motor.
1. Clean the cooling system with a brush weekly or
more frequently if it is necessary.
2. Make sure that the cooling system is not dirty or
blocked.
CAUTION: A dirty or blocked cooling
system can cause the product to
become too hot. This causes damage to
the product.

To sharpen the saw chain

Information about the guide bar and saw chain

WARNING: Use protective gloves when you
use or do maintenance on the saw chain. A
saw chain that does not move can also
cause injuries.
Replace a worn or damaged guide bar or saw chain with
the guide bar and saw chain combination recommended
by Husqvarna. This is necessary to keep the safety
functions of the product. Refer to
Accessories on page
1036 - 003 -