Troubleshooting - Danby DH016A1W Manual Del Propietário

TROUBLESHOOTING

Hours of operation:
Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time
Friday 8:30 am - 4:00 pm Eastern Standard Time
Information in this manual is subject to change without notice.
PROBLEM
No power
Internal temperature not cold enough
Appliance runs continuously
ERROR CODE DESCRIPTION
E0 Environmental temperature sensor fault
E1 Temperature control sensor fault
L1 Storage module communication failure
EH Temperature sensor warning - Internal temperature is 5 degrees higher than the set
temperature for an extended period of time
EL Temperature sensor warning - Internal temperature is 5 degrees lower than the set
temperature for an extended period of time
Dr Door open alarm - This alarm will sound when the door has been open for more than
3 minutes
Danby Consumer Care: 1-800-263-2629
• A fuse may be blown or the circuit breaker
• Plug not fully inserted into the wall outlet
• Temperature setting is too warm
• Door is not shut properly or opened excessively
• Recently added a large quantity of warm food
• Close proximity to heat source or direct sunlight
• Ambient temperature or humidity is very high
• Temperature setting is too cold
• Door not shut properly or opened excessively
• Recently added a large quantity of warm food
• Close proximity to heat source or direct sunlight
• Ambient temperature or humidity is very high
7
POSSIBLE CAUSE
tripped
to the cabinet
to the cabinet