Operating Instructions - Avanti IMD250 Manual De Instrucciones

Starting your Ice maker

Open the reservoir cover door.

Remove any dust or foreign objects that may be in the water reservoir

Using the water fill funnel included with your unit, fill the water tank up to the area marked
"MAX":

Turn the unit ON by pressing the "Power ON / OFF" button.

Select desired ice cube size by pressing the "SELECT" BUTTON (S or L).

The ice-maker will automatically check the water level in the reservoir periodically. The ice
maker will detect any shortage of water and will stop the ice-making cycle, the ADD WATER
indicator will be lit. Turn the unit OFF by pressing the Power ON / OFF button and fill the
reservoir with water. Press the Power ON / OFF button again to restart the ice-making cycle
after the ADD WATER indicator goes out the ice-maker will begin It's normal operation cycle
automatically.

When the ice cubes are collected and reach the bin-full sensor, the ice maker will stop
operating and the ICE FULL indicator will be illuminated.

There are two sizes of ice cubes available, therefore the larger the ice cube selected, the
longer the time it will take to complete the cycle. When the ambient temperature is lower than
15°C (59ºF), the small or medium ice cubes sizes are recommended to avoid ice cubes
clumping together.

For best performance, water temperature should be between 7°C (45ºF) and 35°C (95ºF)
and ambient between 15°C (59ºF) and 25°C (77ºF).

Operating Instructions

11