To Cut Into A Thick Object; To Cut With An Up And Down Movement; To Make A Straight Cut; To Cut Holes - Husqvarna K 7000 Chain Manual Del Usuario

To cut into a thick object

1. Hold the product at an angle as shown in the
illustration.
2. Push the lower end of the guide bar tip 10 cm/3.94
in. into the wall. At the same time, lift the product
body until the guide bar is horizontal.
3. Lower and lift the product body as you continue to
push the guide bar and the diamond chain into the
wall.

To make a straight cut

1. Attach a long straight object as a support along the
line where the cut is to be made.
2. For the best result, cut first with a power cutter with a
Husqvarna special pre-cut blade.
WARNING: Do not use a power cutter
with a standard cutting blade for this first
cut. A standard cutting blade makes a
slot cut that is too thin. When you then
cut with the diamond chain, the too thin
slot causes dangerous kickback and
pinching of the diamond chain.
3. Cut the full length of the cut to a depth of 2-3 cm/
0.79-1.18 in. with the lower end of the guide bar.
Keep the guide bar against the support to make the
cut straight.
4. Lift the guide bar and diamond chain from the cut.
5. Go back to the start of the cut and cut 2-3 cm/
0.79-1.18 in. again, until the full length of the cut has
a depth of 5-10 cm/1.97-3.94 in.
To cut into a thick object on page 16 for
6. Continue to
more instructions.
16

To cut with an up and down movement

1. Use an up and down movement to cut the work
piece. The product is only held straight at the ends of
the cuts.
2. Use the hand guard as a stop.

To cut holes

WARNING: Make sure that large cut pieces
cannot fall on the operator or the product
when you cut.
CAUTION: Cut pieces can fall and cause
damage to the product if the cuts are made
in the incorrect sequence. Always make the
lower horizontal cut before the top horizontal
cut.
1. Attach a support (A) across the area to be cut (B) to
make sure that the cut piece cannot fall.
A
B
1455 - 003 - 03.03.2020