To Cut A Trunk That Has Support On Two Ends; To Cut A Trunk On The Ground; To Cut A Trunk That Has Support On One End; To Use The Limbing Technique - Husqvarna 585, 592 XP, 592 XPG Manuel Del Usuario

2. Apply full throttle and rotate the product. Keep the
spiked bumper against the trunk. This procedure
makes it easier to apply the force necessary to cut
through the trunk.

To cut a trunk on the ground

1. Cut through the trunk on the pull stroke. Keep full
throttle but be prepared for sudden accidents.
WARNING:
chain does not touch the ground when
you complete the kerf.
2. Cut approximately ⅔ through the trunk and then
stop. Turn the trunk and cut from the opposite side.

To cut a trunk that has support on one end

WARNING:
does not break during cutting. Obey the
instructions below.
1. Cut on the push stroke approximately ⅓ through the
trunk.
1471 - 001 - 18.02.2021
Make sure that the saw
1. 2.
Make sure that the trunk
2. Cut through the trunk on the pull stroke until the two
kerfs touch.

To cut a trunk that has support on two ends

WARNING:
chain does not get caught in the trunk during
cutting. Obey the instructions below.
1. Cut on the pull stroke approximately ⅓ through the
trunk.
2. Cut through the remaining part of the trunk on the
push stroke to complete the cut.
WARNING:
chain gets caught in the trunk. Use a lever to
open up the kerf and remove the product.
Do not try to pull the product out by hand.
This can result in injury when the product
suddenly breaks free.

To use the limbing technique

Note:
For thick branches, use the cutting technique.
To use the cutting technique on page 16 .
Refer to
WARNING:
risk when you use the limbing technique.
Kickback information on page 14 for
Refer to
instructions how to prevent kickback.
WARNING:
careful when you remove small limbs and do
not cut bushes or many small limbs at the
same time. Small limbs can get caught in the
2.
1.
Make sure that the saw
1.
2.
Stop the engine if the saw
There is a high accident
Cut limbs one by one. Be
17