To Cut A Trunk That Has Support On Two Ends; To Cut A Trunk On The Ground; To Cut A Trunk That Has Support On One End; To Use The Limbing Technique - Husqvarna 439 Manual Del Usuario

Ocultar thumbs Ver también para 439:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Put the trunk on a saw horse or runners.
WARNING Do not cut trunks in a pile.
That increases the risk of kickback and
can result in serious injury or death.
2. Remove the cut pieces from the cutting area.
WARNING Cut pieces in the cutting area
increase the risk of kickback and that
you can not keep your balance.

To cut a trunk on the ground

1. Cut through the trunk on the pull stroke. Keep full
throttle but be prepared for sudden accidents.
WARNING Make sure that the saw chain
does not touch the ground when you
complete the kerf.
2. Cut approximately ⅔ through the trunk and then
stop. Turn the trunk and cut from the opposite side.

To cut a trunk that has support on one end

WARNING Make sure that the trunk does
not break during cutting. Obey the
instructions below.
823 - 006 - 18.09.2019
1.
2.
1. Cut on the push stroke approximately ⅓ through the
trunk.
2. Cut through the trunk on the pull stroke until the two
kerfs touch.

To cut a trunk that has support on two ends

WARNING Make sure that the saw chain
does not get caught in the trunk during
cutting. Obey the instructions below.
1. Cut on the pull stroke approximately ⅓ through the
trunk.
2. Cut through the remaining part of the trunk on the
push stroke to complete the cut.
WARNING Stop the engine if the saw chain
gets caught in the trunk. Use a lever to open
up the kerf and remove the product. Do not
try to pull the product out by hand. This can
result in injury when the product suddenly
breaks free.

To use the limbing technique

Note For thick branches, use the cutting technique.
To use the cutting technique on page 14 .
Refer to
WARNING There is a high accident risk
when you use the limbing technique. Refer
Kickback information on page 12 for
to
instructions how to prevent kickback.
WARNING Cut limbs one by one. Be careful
when you remove small limbs and do not cut
bushes or many small limbs at the same
2.
1.
1.
2.
15

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido