Dremel 7300 Instrucciones De Funcionamiento Y Seguridad página 19

1600A012FS_7300 2/1/17 10:17 AM Page 19
Store accessories in a dry and temperate environment to avoid corrosion and deterioration.
The number and variety of accessories for the Rotary Tool are almost limitless. There is a category suited to
almost any job you might have to do and a variety of sizes and shapes within each category which en ables you
to get the perfect accessory for every need.
If you expect to use a variety of accessories, we rec-
ommend that in the beginning you purchase a com-
plete set of four collets. Store these so that you will
have the proper size of collet for any accessory or drill
bit you want to use. Currently, the 1/8", 3/32",1/32"
and 1/16" collets accommodate all of the avail able
Dremel accessories. 1/8" collets are included in
most rotary tool kits.
A mandrel is a shank with a threaded or screw head,
which are required when you use polishing acces-
sories, cutting wheels, sanding discs, and pol ish ing
points. The reason mandrels are used is that sanding
discs, cutting wheels and similar accesso ries must be
replaced frequently. The mandrel is a per manent shank,
allowing you to replace only the worn head when nec-
essary, thus saving the expense of replacing the shaft
each time.
Screw Mandrel No 401
This is a screw mandrel used with the felt polishing
tip and felt polishing wheels. 1/8" shank.
Dremel Accessories
Use only Dremel®, high-performance accessories. Other accessories are not designed
for this tool and may lead to personal injury or property damage.
COLLETS
MANDRELS
Small Screw Mandrel No 402
This is a mandrel with a small screw at its tip, and is
used with emery and fiberglass cutting wheels, sand-
ing discs and polishing wheels. 1/8" shank.
EZ Lock Mandrel No 402
The Dremel EZ Lock makes accessory changes easy
as PULL - TWIST - RELEASE. The one-piece mandrel
design simplifies the process of changing cutting
wheels, buffs and detail abrasive brushes (EZ Lock
compatible accessories).
EZ Drum™ Mandrel No EZ407SA
The Dremel EZ Drum makes accessory changes easy
as PULL - INSERT - PRESS DOWN. The one-piece
mandrel design simplifies the process of changing
sanding bands.
19