1600A012FS_7300 2/1/17 10:17 AM Page 25
EZ Lock™ Mandrel No. EZ402 has a spring loaded
sleeve and is used with cutting wheels, abrasive buffs
and polishing cloth.
the plug from the power source or the battery pack
from the tool before changing accessories. Such
preventative safety measures reduce the risk of start-
ing the power tool accidentally.
Always make sure accessory is properly seated on
mandrel before use. Incorrect seating of accessory on
mandrel may lead to personal injury or property damage.
To load accessory:
1. Place EZ Lock™ mandrel into collet as deep as pos-
sible and tighten collet nut.
Note: There is a blue spacer that will bottom out on
the collet nut, setting the mandrel to the correct
depth. When using with Dremel chuck, back the
mandrel out slightly before tightening.
2. Pull spring-loaded sleeve DOWN towards tool with
one hand and hold. You can brace the tool on the
body or work-bench for extra leverage (Fig. 1).
3. With the other hand, align bowtie shape on cut-off
wheel with mandrel and make sure metal insert is
facing away from the tool (Fig. 2).
4. Place wheel on the mandrel to a point just below
the bowtie on the mandrel and twist 90 degrees
until the bowtie shape on the wheel aligns with the
sleeve. Release sleeve. Wheel should lock in place
(Fig. 3).
5. When mounting sanding and polishing acces-
sories, align bowtie with metal insert on bottom of
accessory (Fig. 4 & 5).
To check for proper seating, hold shaft lock button
and twist accessory. Accessory will not be able to
rotate on mandrel.
To unload accessory:
1. Pull spring-loaded sleeve DOWN toward tool with
one hand (Fig. 1).
2. Hold sleeve down while twisting accessory 90
degrees.
3. Remove accessory.
Avoid damage to EZ lock™ mandrel by not letting it
contact the workpiece.
EZ Lock™ Operating Instructions
Always make sure the rotary
tool is "OFF" and disconnect
During use
FIG. 1
FIG. 2
FIG. 3
FIG. 4
25
FIG. 5