Sony VPL-SW636C Manual De Referencia página 60

Fitting the projected image to the screen (Digital Shrink adjustment)
If the projected image exceeds the size of the screen, you can shrink and adjust the position of it.
1 Select "Rid. digitale" in the Installation menu.
2 Set the shrinking rate.
Press the V/v/B/b key to adjust the value. The more the value increases towards the plus side,
the smaller the projected image becomes.
3 Press the ENTER button to display the shift adjustment menu and adjust the display position of
the projected image.
Press the V/v/B/b key to adjust the display position.
Notes
• If the shrinking rate is set to "0," you cannot move the image. If the projector is projecting an
image with a resolution that is different from the panel display resolution of this projector, it may
not be possible to move the image.
• When you use the PC Free Interactive function or mouse mode, do not perform Digital Shrink
adjustment. The position of the Interactive Pen Device may slip off out of the image (VPL-
SW636C only).
Displaying a pattern
You can display a pattern for adjusting the projected image or a grid pattern with the PATTERN
key on the remote commander. Press the PATTERN key again to restore the previous image.
You can use a grid pattern as a guide to write text or to draw lines and shapes on the whiteboard
or blackboard without using a computer.
Note
You cannot use this key when "Type A USB", "Type B USB" or "Network" is selected as the input.
Automatically adjusting Phase, Pitch, and Shift of the projected image while
a signal is input from a computer (APA (Auto Pixel Alignment))
Press the APA key on the remote commander. Press again to cancel adjusting during the setting.
You can also set APA in the Screen Menu. If Smart APA in the Function menu is set to "On",
executes APA automatically when a signal is input.
20
GB
Projecting an Image