Sony VPL-CX100 Manual De Referencia Rápida página 27

Notes
• Be careful not to touch the glass surface
of the lamp.
• The power will not turn on if the lamp is
not secured properly.
6
Restore the lamp cover to the original
position and tighten the three screws
with the Phillips screwdriver.
Note
Be sure to attach the lamp cover securely
as it was. If not, the projector cannot be
turned on.
7
Connect the power cord.
The ON/STANDBY indicator lights in
red.
8
?/1
Press the key to turn the projector on.
9
Press the MENU key, and then select the
Setup menu.
10
Select "Lamp Timer Reset," and then
press the ENTER key.
11
Select "Execute" with the
press the ENTER key.
The Lamp Timer is initialized to 0.
"Change the Lamp and clean the Filter?"
is displayed in the menu screen.
Change the Lamp and clean the Filter?
Yes:
Refer to "Cleaning the Air Filter."
12
Select "Yes" with the
"Lamp Timer Reset Complete!" is
displayed in the menu screen.
Note
To erase a message, press any key on the control
panel of the projector or on the Remote
Commander.
Disposal of the used lamp
For the customers in the USA
Lamp in this product contains mercury.
Disposal of these materials may be
regulated due to environmental
considerations. For disposal or recycling
information, please contact your local
authorities or the Electronic Industries
Alliance (www.eiae.org).
Replacing the Lamp
V
key, and then
No:
v
key.
11
GB