Cleaning And Maintenance; Technical Data - Beper 50101 Manual De Instrucciones

EN
Steam iron Use instructions
DRY IRONING:
The steam iron can also be used dry with or without water in the water tank. However, it would be better to avoid
filling the water tank while ironing.
Set the steam control button to the minimum position.
Set the thermostat knob to the most suitable temperature for the fabric to be ironed.
STEAM SHOT:
The steam shot is used to remove the most stubborn creases.
Set the thermostat knob to the position "● ●" or "● ● ●".
Set the steam setting button to the maximum position.
Press the steam shot button.
NOTE: To avoid water leaking from the plate, do not hold the steam shot button for more than 5 seconds.
END OF IRONING
When you finish ironing set the thermostat knob to the minimum position.
Unplug the power cord from the power outlet.
Put the iron upright.

CLEANING AND MAINTENANCE

Before cleaning the iron, make sure that it is unplugged from the power supply and completely cooled.
It is recommended not to use abrasive detergents.
SELF CLEAN (AUTO-CLEANING)
Fill half of the water tank.
Set the thermostat knob to the maximum position and the steam setting button to the minimum position.
Insert the power cord into the wall socket.
Let the iron warm up until the light switches off.
Holding the iron in a horizontal position above the sink, place the steam selector in the maximum position, press
the "Self Clean" button.
The boiling water, the steam and the impurities will be expelled from the holes in the plate.
Unplug the power cord from the power outlet.
Wait until the iron is cold before storing it.
ANTI-CALC SYSTEM
A special resin filter inside the water tank softens the water and prevents limescale build-up in the plate. The
resin filter is permanent and does not require replacement.
Note:
Do not use chemical additives, scented substances or descaling agents. Failure to comply with the abo-
ve mentioned regulations will make a loss of the warranty.
ANTI-DROP SYSTEM
With the anti-drop system, even the most delicate fabrics can be ironed perfectly and it is recommended to
always iron at low temperatures.
The plate can cool down to the point where no more steam will come out, but drops of boiling water may come
out and may leave marks or stains. In this case, the anti-drip system is activated automatically to prevent vapo-
rization, so you can iron the most delicate fabrics without risking to damage or stain them.
STORAGE
Unplug the power cord from the power outlet, empty the water tank (do it after each use) and allow the iron to
cool completely.
Wrap the cord around the base.
To protect the plate, place the iron in an upright position.

TECHNICAL DATA

Power: 2200W
Power supply: 220-240V ~ 50-60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
11