Flash Bracketing Series („Fb") - Metz MECABLITZ 50 AF-1 digital Manual De Instrucciones

9.3 Flash bracketing series („FB")
A series of flash exposures FB (flash bracketing) can be carried out in the TTL
TTL TTL
flash modes (P , P HSS; see 7.1). A flash bracketing series consists of
three successive flash shots with different flash exposure correction values:
• The first shot is carried out without correction value.
• The second shot is made with a minus correction.
• The third shot is made with a plus correction .
• After the third shot, the flash bracketing series is automatically deleted.
A flash bracketing series can only occur if the camera supports the
setting of a manual flash exposure correction on the flash unit (see ch. 8
and the camera's operating instructions)! Otherwise the shots will be
made without correction values!
Setting procedure
FB
FB
1,3
FB
1,3
FB
• Press the button combination „Select" until
„FB" flashes in the display.
• Apply the setting desired with the buttons
+ and —. The possible correction values
range from 1/3 to 3 apertures in one-
third aperture increments. The correction
value will always be shown positively.
The setting takes effect immediately.
After about 5 seconds the display stops
flashing and the setting is saved automati-
cally.
For the first shot of a flash bracketing series „FB" and „A"re shown in the
display.
For the second shot „FB", „B" and the minus correction values are displayed.
For the third shot „FB", „C" and the plus correction values are displayed. After
the third shot, „FB" is deleted from the display and the flash bracketing series is
deactivated.
It must be reset for another flash bracketing series!
101