Spot-Beam Mode „Sb - Metz MECABLITZ 50 AF-1 digital Manual De Instrucciones

Setting procedure
P TTL
P TTL
HSS
HSS
8,1 35
m mm
Auto Zoom
High-speed synchronisation can be deleted by repeatedly pressing the „Mode"
button until the „HSS" symbol disappears.
Second curtain synchronisation (REAR) is automatically deactivated when
the flash unit is set to high-speed synchronisation FP or HSS!
• repeatedly press the„Mode" button
TTL
until„P HSS" flashes in the display.
The setting takes effect immediately.
After about 5 seconds the display stops
flashing and the setting is saved automa-
TTL
tically. „P HSS" is shown in the
display.
7.4 Spot-beam mode „Sb"
In the spot beam mode, the AF measuring beam can be used to focus on a
subject at low ambient light level without firing a flash when the shot is taken.
There is no flash-ready indicator in spot beam mode and no exposure control
indicator in the camera viewfinder. The camera is not set to its sync speed and
behaves as though there were no flash unit connected.
Spot beam mode is only activated when the flash unit is switched on and
is flash-ready (check the flash-ready indicator on the flash unit!).
When the camera shutter is released, no flash is fired. Please read the notes on
the AF measuring beam in chapter 12.
Setting procedure
• repeatedly press the„Mode" button
until„Sb" flashes in the display.
The setting takes effect immediately.
After about 5 seconds the display stops flashing and
the setting is saved automatically. „Sb" is shown in
the display.
Sb
Sb 35
mm
Zoom
95