Riello RL 70/M Instrucciones De Instalación, Funcionamiento Y Mantenimiento página 18

6.1.1 Electrical connections (Fig. 16)
RL 70/M
RL 100/M - RL 130/M
RL 70-100-130/M electrical connection three-phase 230/400 V power supply with neutral phase wire
RL 70/M - RL 100/M - RL 130/M
RL 70/M
230 V 400 V 230 V 400 V 230 V 400 V
F A T10
L 1.5 1.5
2
mm
Fuses and cables section layout, see table (Fig. 18).
Cable section not indicated: 1.5 mm
2915996
D3146
RL 100/M RL 130/M
T6 T16 T10 T16
1.5 1.5 1.5
2
.
Electrical system
Set up by the installer
Use flexible cables according to regulation EN 60 335-1:
 if in PVC boot, use at least H05 VV-F
 if in rubber boot, use at least H05 RR-F.
All the cables to be connected to the burner terminal strip
8)(Fig. 17 Fig. 16) must be routed through the fairleads.
The fairleads can be used in various ways. One example is given
below:
RL 70/M (Fig. 16)
D1225
1 Pg 13,5
2 Pg 11
3 Pg 11
4 Pg 9
Fig. 16
5 Pg 9
6 Pg 11
7 Pg 13,5
RL 100/M - RL 130/M (Fig. 17)
1 Pg 13,5
2 Pg 11
3 Pg 11
4 Pg 13,5
5 Pg 9
6 Pg 11
Fig. 17
T10
1.5
16 GB
Three-phase power supply
Single-phase power supply
Control device TL
Control device TR or probe (RWF)
Set up for faird lead
Set up for faird lead
Set up for faird lead
Three-phase power supply
Single-phase power supply
Control device TL
Control device TR or probe (RWF)
Set up for faird lead
Set up for faird lead
D866
Fig. 18