Installation; Handling; Preliminary Checks - Riello RL 70/M Instrucciones De Instalación, Funcionamiento Y Mantenimiento

5

Installation

Notes on safety for the installation
After carefully cleaning all around the area where the burner will be installed, and arranging the correct lighting of the environment,
proceed with the installation operations.
All the installation, maintenance and disassembly
operations must be carried out with the electricity
supply disconnected.
DANGER
5.1

Handling

The packaging of the burner includes a wooden platform, so it is possible to move the burner (still packaged) with a transpallet truck
or fork lift truck.
The handling operations for the burner can be highly dangerous if not carried out with the greatest attention: keep any
unauthorised people at a distance; check the integrity and suitableness of the available means of handling.
Check also that the area in which you are working is empty and that there is an adequate escape area (i.e. a free, safe
area to which you can quickly move if the burner should fall).
WARNING
During the handling, keep the load at not more than 20-25 cm from the ground.
After positioning the burner near the installation point, correctly dispose of all residual packaging, separating the various
types of material.
Before proceeding with the installation operations, carefully clean all around the area where the burner will be installed.
CAUTION
5.2

Preliminary checks

Checking the consignment
After removing all the packaging, check the integrity of the contents. In the event of doubt, do not use the burner; con-
tact the supplier.
CAUTION
The packaging elements (wooden cage or cardboard box, nails, clips, plastic bags, etc.) must not be abandoned as
they are potential sources of danger and pollution; they should be collected and disposed of in the appropriate places.
Checking the characteristics of the burner
A
B
D
RIELLO S.p.A.
I−37045 Legnago (VR)
D8965
Check the identification label of the burner, showing:
 the model (see A in Fig. 4) and type of burner (B);
 the year of manufacture, in cryptographic form (C);
 the serial number (D);
 the electrical input power (E);
 the types of fuel used and the relative supply pressures (F);
 the data of the burner's minimum and maximum output pos-
sibilities (G) (see Firing rate).
2915996
G
C
E
F
Installation
The installation of the burner must be carried out
by qualified personnel, as indicated in this manual
and in compliance with the standards and regula-
tions of the laws in force.
WARNING
The output of the burner must be within the boil-
er's firing rate.
WARNING
A burner label that has been tampered with, re-
moved or is missing, along with anything else that
prevents the definite identification of the burner
0036
makes any installation or maintenance work diffi-
WARNING
cult.
Fig. 4
10 GB