Stihl MSE 140 C Manual De Instrucciones página 39

English / USA
Furthermore, the angles must be the
same on all cutters. If angles are uneven
the chain will run roughly, not in a
straight line, wear quickly and break
prematurely.
As these requirements can be met only
after sufficient and constant practice:
: Use a file holder
Always use a file holder for manual
resharpening chains (special accessory
– see Table "Sharpening Tools"). The
correct filing angle is marked on the file
holder.
38
For checking angles
90°
85° 70°
80°
60°
30° 35°
10° 0°
Use a STlHL filing gauge (special
accessory – see table "Sharpening
Tools"). This is a universal tool for
checking the filing and side plate angles,
depth gauge setting and cutter length. It
also cleans the guide bar groove and oil
inlet hole.
File correctly
: Disconnect plug from power
supply.
: Select sharpening tools to suit the
chain pitch.
: Clamp the bar in a vise if necessary.
: Lock the chain in position by
engaging the chain brake –
push the hand guard forwards.
: To move the chain along the bar,
disengage the chain brake by
pulling the hand guard towards the
front handle.
On models MSE 140 C, MSE 160 C,
MSE 180 C and MSE 200 C:
Hold the hand guard in this position
to deactivate the coasting brake.
: Sharpen the chain frequently; take
away as little metal as possible –
two or three strokes of the file are
usually enough.
MSE 140 C, MSE 160 C, MSE 180 C, MSE 200 C
90°