Yamaha MLA-200 Manual De Instrucciones página 2

FCC INFORMATION (U.S.A.)
1. IMPORTANT NOTICE:
DO NOT MODIFY THIS UNIT!
This product when installed as indicated in the
instructions contained in this manual, meets
FCC requirements. Modifications not expressly
approved by Yamaha may void your authority,
granted by the FCC, to use the product.
2. IMPORTANT:
accessories and/or another product use only
high quality shielded cables. Cable/s supplied
with this product MUST be used. Follow all
installation instructions. Failure to follow
instructions could void your FCC authorization to
use this product in the USA
3. NOTE:
This product has been tested and found
to comply with the requirements listed in FCC
Regulations, Part 15 for Class "B" digital
devices. Compliance with these requirements
provides a reasonable level of assurance that
your use of this product in a residential
environment will not result in harmful
interference with other electronic devices. This
equipment generates/uses radio frequencies
and, if not installed and used according to the
instructions found in the users manual, may
cause interference harmful to the operation of
(Supplier's declaration of conformity procedure)
Responsible Party : Yamaha Corporation of America
Address : 6600 Orangethorpe Ave., Buena Park, Calif. 90620
Telephone : 714-522-9011
Type of Equipment : Music Laboratory System
Model Name : MLA-200
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received including interference that may
cause undesired operation.
CAN ICES-3 (B)/NMB-3(B)
2
MLA-200 Owner's Manual
When connecting this product to
COMPLIANCE INFORMATION STATEMENT
(can_b_02)
other electronic devices. Compliance with FCC
regulations does not guarantee that interference
will not occur in all installations. If this product is
found to be the source of interference, which
can be determined by turning the unit "OFF" and
"ON" please try to eliminate the problem by
using one of the following measures:
Relocate either this product or the device that is
being affected by the interference.
Utilize power outlets that are on different branch
(circuit breaker or fuse) circuits or install AC line
filter/s.
In the case of radio or TV interference relocate/
reorient the antenna. If the antenna lead-in is
300 ohm ribbon lead, change the lead-in to co-
axial type cable.
If these corrective measures do not produce
satisfactory results, please contact the local
retailer authorized to distribute this type of
product. If you cannot locate the appropriate
retailer, please contact Yamaha Corporation of
America, 6600 Orangethorpe Ave. Buena Park
CA90620, USA
The above statements apply ONLY to those
products distributed by Yamaha Corporation of
America or its subsidiaries.
(class B)
(FCC SDoC)