Rear Panel; Dip Switch - Yamaha MLA-200 Manual De Instrucciones

Part names and functions
i [I/O] port
Connect an instrument. MIDI
information is sent to and received from
the application and other instruments.
Use for the guide lamp feature with
model songs and for receiving song
data from the application.
NOTE
Use a USB cable of 3 m or less.
o [INPUT] jack
Connect with the PHONES
(headphones) jack on the instrument.
This is a standard stereo headphones
input.
!0 [INPUT GAIN] switch
Switch the input gain for the [INPUT]
jack to one of two settings. This switch
is normally set to "0 dB". When
connecting an instrument with a low
output, set the switch to "+10 dB".
8
MLA-200 Owner's Manual

Rear panel

!1

!1 DIP switch

Set the unit ID for the MLA-200. Also
use to initialize the MLA-200.
Be careful not to change the DIP switch
settings except when configuring or
changing system settings.
Be sure to consult with a system
installer before operating the DIP
switch. For details on the setting
procedures, refer to the Setup Guide.