Using The Subwoofer (Yst-Sw45); Controls And Their Functions; Front Panel - Yamaha NS-P610 Manual De Instrucciones

USING THE SUBWOOFER (YST-SW45)

Controls and their functions

POWER
5
1
Power indicator
Lights up while the subwoofer is turned on.
* If the STANDBY/ON (
the AUTO STANDBY (
or LOW position, this indicator lights up dimly when
no signal is inputted to the subwoofer.
2
STANDBY/ON button
Press this button to turn on the power. Press again to
set the subwoofer in the standby mode.
* This button can be used only when the POWER (
switch is set in the ON position.
Standby mode
The subwoofer is still using a small amount of power
in this mode.
3
HIGH CUT control
Adjusts the high frequency cut off point.
Frequencies higher than the frequency selected by this
control are all cut off (and no output).
* One graduation of this control represents 10 Hz.
10
E-

Front panel

STANDBY/ON HIGH CUT VOLUME
50Hz 150Hz 0 10
SUPERWOOFER SYSTEM YST-SW45
Rear panel
(General model)
OUTPUT INPUT2 AUTO
TO SPEAKERS STANDBY
LOW HIGH
OFF
FROM AMPLIFIER
INPUT1
ON
OFF
VOLTAGE
SELECTOR
240V
POWER
ON
OFF
2
) button is pressed in and
9
) switch is set to the HIGH
100 Hz
90 Hz 110 Hz
80 Hz 120 Hz
70 Hz 130 Hz
60 Hz 140 Hz
50 Hz 150 Hz
STANDBY/ON HIGH CUT
50 Hz
1 2 3
OUTPUT
TO SPEAKERS
6
7
FROM AMPLIFIER
INPUT1
VOLTAGE
SELECTOR
240V
0
4
VOLUME control
Adjusts the volume level. Turn the control clockwise to
increase the volume, and counterclockwise to
decrease the volume.
5
POWER switch
Normally, set this switch to the ON position to use the
subwoofer. In this state, you can turn on the subwoofer
or turn the subwoofer into the standby mode by
pressing the STANDBY/ON (
5
) switch to the OFF position to completely cut off the
subwoofer's power supply from the AC line.
6
OUTPUT (TO SPEAKERS) terminals
Can be used for connecting to the main speakers.
Signals are sent directly from the amplifier to the main
speakers by way of these terminals.
(Refer to "CONNECTIONS" for details.)
7
INPUT1 (FROM AMPLIFIER) terminals
Used to connect the subwoofer with the speaker
terminals of the amplifier.
(Refer to "CONNECTIONS" for details.)
VOLUME
150 Hz 0 10
4
INPUT2 AUTO
STANDBY
LOW HIGH
OFF
8 9
2
) button. Set this