Controlling The Tv Via The Sound Bar (When The Tv's Remote Control Sensor Is Blocked); Using An External Subwoofer - Yamaha YAS-152 Manual De Instrucciones

Controlling the TV via the sound bar (when the TV's
remote control sensor is blocked)
When the TV Remote Repeater function is enabled, the sound bar receives TV remote
control signals at the TV remote control sensor (on front) and transmits the signals from
the TV Remote Repeater (on rear). This function is useful when you cannot operate your
TV from the remote control because the remote control sensor of the TV is blocked by
the sound bar.
NOTE
• This function is available only when your TV remote control uses infrared signals.
TV Remote Repeater
TV remote control
1
Turn on the sound bar.
2
Hold down the REPEATER key on the supplied remote control for
more than 3 seconds to enable/disable the TV Remote Repeater
function.
This completes the necessary settings. When the TV Remote Repeater function is
enabled, you can operate your TV from the TV remote control via the sound bar.
HINT
• The TV Remote Repeater function is disabled by default.
• If the power cable of the sound bar is connected to an AC wall outlet and when the TV Remote
Repeater function is enabled, the function is usable even when the sound bar is turned off.
• If you have made the sound bar learn the volume (+) operation (p.12), the volume of the TV may be
turned up when you turn up the volume of the sound bar with the TV remote control. In this case,
follow Step 3 in "Connections" (p.5) to change the TV setting.
• You can check the status of the TV Remote Repeater function by the center indicator when turning
on the sound bar.
TV's remote control sensor
Flash 3 times (enabled), Flash once (disabled)
Off (enabled), lights up (disabled)

Using an external subwoofer

The sound bar has dual built-in subwoofers; however, you can connect an external
subwoofer. Perform the following steps to change the setting when using an external
subwoofer.
1
Connect the sound bar to the external subwoofer with a pin cable.
2
With the sound bar turned off, hold down the SUBWOOFER (-) key on
the supplied remote control for more than 5 seconds.
The sound bar turns on and the external subwoofer is selected.
You can check the status of the subwoofer setting by the ANALOG indicator when
turning on the sound bar.
Off (external subwoofer), lights up (built-in subwoofer)
To select the built-in subwoofers again, hold down the SUBWOOFER (+) key of the
remote control for more than 5 seconds.
NOTE
• The default output setting is for the built-in subwoofers.
• The built-in subwoofer and external subwoofer cannot be used simultaneously.
• Use an external subwoofer with built-in amplifier.
Mono input
13