Preparing The Remote Control; Installing The Product - Yamaha SR-C30A Guia De Incio Rapida

Preparing the remote control

A Lithium battery (CR2025) has already been inserted into the remote
control. Pull out the insulation sheet as follows so as to use the
remote control.
Operating range of the remote control
The remote control can be used to control the functions of this
product. When using the remote control, point the remote control at
the remote control sensor of the sound bar within the range shown in
the following illustration:
Remote control
sensor
Remote control
Battery insulating strip
Within 6 m (20 ft)

Installing the product

Install the sound bar and subwoofer as shown in the following
illustration:
 NOTE
• The subwoofer can also be used on its side.
See the User Guide for details.
For the proper installation of the sound bar on
a wall, make sure to have it done by a
qualified contractor. See the Wall Mounting
Installation Guide on our website for the
installation method.
Attach the non-skid
pads to the bottom
of the subwoofer.
User Guide
Wall Mounting
Installation Guide
5
En