Maintenance - Truper PIPI-420 Manual De Uso

Cleansing and Care
• It is very important to clean the paint gun thoroughly
after each use.
WARNING Inadequate cleansing will result in
malfunctioning and will cancel the Warranty.
• Without removing the jar press the trigger to remove all
the product inside the system.
• Pour the remaining material into an adequate container.
• Disconnect the paint gun hose.
• Clean the jar, the gasket seal and the suction pipe
thoroughly with a rag soaked with the solvent that is right
for the product.
• Disassemble the regulator, the sprayer, the nozzle and
the needle. Clean them with a brush and solvent.
• Clean the paint gun body with a piece of rag moistened
with solvent.
CAUTION Do not immerse the gun in solvent. The
gaskets may get damaged.
• When the parts are clean assemble back the paint gun.
• Pour a small amount of solvent into the jar. Connect the
hose to the paint gun.
• Turn on the compressor and spray into a container until
getting clean solvent out through the nozzle.
Needle Seal
• Use special care adjusting the needle seal. This is
important to get a better job.
• Using the wrench adjust the needle seal (A).
• Check the seal often to assure it is not damaged. To gain
access to the seal, remove the needle and remove the
seal pressing part (B).
A
8
ENGLISH

Maintenance

B