Maintenance - Truper PITI-687 Manual De Instrucciones

Cleansing and Care
• It is very important to clean the texture gun thoroughly
after each use.
WARNING • Cleaning the machine carelessly will, in
the long run, lead to malfunctioning and will nullify the
Warranty.
• Never immerse the texture gun in
WARNING
solvent. The washers may be damaged.
• Wear gloves and safety glasses.
• Disconnect the hose from the plastering machine.
Remove nozzle and hopper.
• Clean the hopper and the texture gun body with a cloth
damp with water.
• For a deeper cleansing, disassemble the rest of the
components. Clean with a brush and water, or air-blow the
texture gun to eliminate any texture material or water
inside the components.
• Before assembling back, apply a small amount of grease
(grease for wheel bearings or lithium based) in all the
O-rings. Slide the pneumatic stud in the texture gun from
back side of the machine and set the knobs in each of their
positions.
• Use care with the O-rings when reassembling the
pneumatic stud. The O-rings may get cut in the threads or
rip inside the texture gun inside chamber wall. Set the
adequate nozzle.
• Rest the machine in an inverted position and place 5 to
10 drops low viscosity and domestic use oil in the fast
connection. This will make the oil lubricate the pneumatic
stud and the O-rings. After lubricating with oil, press the
trigger a couple of times.
• Connect back the compressor hose and purge using
water to remove all the remaining texture material.
8
ENGLISH

Maintenance