Maintenance - Truper PIPI-400 Manual Del Usario

Cleansing and Care
• It is very important to clean the gun thoroughly after each
use.
WARNING In the long run, inadequate cleaning will
result in poor functioning and will void the warranty.
• Empty the remaining fluid from the cup into a designated
container.
• Not removing the cup, press the trigger to remove all the
fluid from inside the system.
• Poor a little bit of solvent into the cup.
• Start the compressor and spray into a container until
clean solvent passes through the nozzle.
• Disconnect the hose from the gun.
• Disassemble the cup, the sprayer, the nozzle and the
needle to clean with a soft brush and solvent.
• Clean the gun body with a piece of cloth dampened with
solvent.
CAUTION Do not submerge the gun in solvent.
Otherwise, the washers may get damaged.
• Once the parts are clean, assemble back the gun.
Needle Seal
• Use special care when adjusting the needle seal. It is
important for a good job.
• Adjust the needle seal using the wrench (B).
• Periodically check the seal to double check is not
damaged. To gain access to the seal remove the needle
and remove the seal oppressive piece in the seal (C).
8
ENGLISH

Maintenance

B
C