To Examine The Direction Of Rotation Of The Cutting Blade; To Do A Check Of The Arbor Bushing; To Install The Cutting Blade - Husqvarna K1270 II Manual Del Usuario

1. Make sure that the threads on the spindle shaft are
not damaged. Replace damaged parts.
2. Make sure that the areas of contact on the cutting
blade and the flange washers are not damaged.
Replace damaged parts.
3. Make sure that the flange washers are clean and of
the correct dimension.
4. Make sure that the flange washers move freely on
the spindle shaft.

To do a check of the arbor bushing

The arbor bushings are used to attach the product to the
center hole of the cutting blade. The product is supplied
with one of these two types of arbor bushings:
• An arbor bushing that can be turned to the other side
and be applicable for 20 mm/0.79 in. or 25.4 mm/1
in. center holes.
• A 25.4 mm/1 in. arbor bushing.
• A decal on the blade guard shows installed arbor
bushing and specification for applicable cutting
blades.
• Make sure that the dimension of the center hole of
the cutting blade agrees with the installed arbor
bushing. The diameter of the center hole is printed
on the cutting blade.
• Use only Husqvarna arbor bushings.
14
To examine the direction of rotation of
the cutting blade
1. Find the arrows on the cutting arm that show the
direction of rotation of the spindle shaft.
2. Find the arrow on the cutting blade that shows the
direction of rotation of the cutting blade.
3. Make sure that the direction arrows of the cutting
blade and the spindle shaft have the same direction.

To install the cutting blade

WARNING: Make sure that the engine is off
and that the stop switch is in STOP position.
WARNING: Always use protective gloves
when you assemble the product.
1. Examine the flange washers and the spindle shaft.
To examine the spindle shaft and the flange
Refer to
washers on page 13 .
2. Put the cutting blade on the arbor bushing (A)
between the inner flange washer (B) and the flange
washer (C). Turn the flange washer until it hold on to
the shaft.
B
A
C
988 - 002 -