Transportation of the product
•
Make sure that the Longopac bag is empty before a
transportation
•
Make sure that the Longopac bag is attached to the
product during transportation.
•
Make sure the inlet plug is inserted into the main
tank and the hose is attached with both ends to the
pre separator (T 4000 Petrol Soff-Cut)
•
Be very careful when you move the product up and
down ramps. The product is heavy and there is a risk
of injury if the product falls or moves too quickly. For
ramps with a large angle, always use a winch. Do
not walk or stay below the product.
•
Tie down the product safely during transportation, by
using the tie down lugs, in order to prevent damage
and accidents.
•
Engage the locking caster safely on the wheels.
•
If possible, do the transportation of the product
during good weather conditions.
•
If possible, use a closed vehicle during
transportation of the product.
•
If the engine has been running, allow it to cool for at
least 15 minutes before loading the engine-powered
equipment onto the transport vehicle. A hot engine
and exhaust system can burn you and can ignite
some materials.
•
During transportation, battery must be securely
fastened and completely disconnected at all times.
Storage of the product
•
The product must be stored inside away from
outdoor elements.
•
Do not expose the product to rain or moisture.
•
Attach the locking casters safely.
•
Store the product and the equipment in a dry area
with no frost or excessive heat.
•
Store all equipment in an locked area, so that it is
out of reach of children and unauthorized persons.
Disposal of the product
•
Obey the local recycling requirements and applicable
regulations.
•
When the product no longer is used, send it to the
dealer or discard it at a recycling location.
14
Transportation, storage and disposal
1105 - 001 - 11.07.2019