Before starting
WARNING! Please read the operator's
!
manual carefully and make sure you
understand the instructions before using
the machine.
Wear personal protective equipment. See
instructions under the heading "Personal
protective equipment".
Make sure no unauthorised persons are
in the working area, otherwise there is a
risk of serious personal injury.
•
Check that the machine is assembled correctly and do
not show any signs of damage. See instructions in the
section "Assembling and adjustments".
•
Perform daily maintenance. See instructions in the
section "Maintenance".
Starting
•
Check that the emergency stop button is not pressed
by turning it clockwise.
POWER
STOP
STOP
RUN
RESET
22 – English
STARTING AND STOPPING
•
Check that the STOP/RUN switch is set to STOP.
POWER
STOP
STOP
RUN
RESET
•
Press the power button. On doing so, a soft 'clunk"
should be heard to come from within the electrical
cabinet. This indicates the line contactors have
engaged, supplying power to the drives/frequency
converters.
POWER
STOP
STOP
RESET
•
Reduce the pressure between grinding disc and floor
by pushing down the handle without lifting the grinding
unit from the floor when starting.
•
Switch the machine to run mode using the STOP/RUN
switch on the control panel. The machine should start
RUN