The Product Has Sudden Movements; Transportation And Storage; To Set The Product In Transport Position; The Product Stops During Startup - Husqvarna PG 510 Manual Del Usuario

The product has sudden movements

• Make sure that all diamond tools are installed
correctly and that all have the same height.
The product stops after only a while
• If the product overloads, the overload protection
engages and stops the motor.
• Decrease the load. The lower hole is for a higher
handlebar and increased grind pressure. The top
hole is for a lower handlebar and decreased grind
pressure.
• The product restarts after approximately a minute,
when the temperature of the motor is decreased to
usual level.

To set the product in transport position

Put some type of protection on the product during
transportation. The protection keeps natural elements
such as rain and snow away from the product.
The product can be divided into 2 components. This
makes the transportation easier.
Always move the product with the lifting eye and the
handlebar.
1. Disconnect the motor cable from the electric
enclosure (A).
1146 - 001 - 29.04.2019

Transportation and storage

A
• Make sure that the extension cables are not too
short.

The product stops during startup

Correct voltage supply is necessary for a good motor
performance. Too long extension cables and/or a too
small gauge decreases the power of the motor during
operation.
• If the motor overloads, the overload lamp comes on.
Wait 2 minutes and try again. When this does not
help, speak to an approved service workshop.
• Make sure that the extension cables are not too
short.
2. Pull out the lock pins (A) and remove the lock bolts
(B) on each side of the grinding head
B
.
A
15