Adjust The Saw Carriage - Husqvarna WS 482 HF Manual De Instrucciones

ASSEMBLING AND ADJUSTMENTS
Turn the shafts gently with a 16mm wrench until the guide
wheels rest agains the rail.
Hold the 16 mm wrench in position and tighten the two stop
screws with a 3 mm allen key.
Press down the locking device and pull the saw carriage in
both directions by hand. Carriage should slide easily with a
slightly resistance. All 4 guide wheel should spin.
Tighten screws with a 8 mm allen key. Repeat the previous
step.

Adjust the saw carriage

As the saw wears, after a number of hours working, it can be
a good idea to ensure that the saw sits firmly in the saw
carriage and rail. If not, the handle probably needs adjusting:
12 –
English
Loosen the two stop screws with a 3 mm allen key.
Turn the two excenter sleeves with a 8 mm allen key until the
shaft is tight and parallell to the saw unit.
Tighten the two stop screws with a 3 mm allen key.
Make sure the locking handle is properly adjusted by open
and close and see that the spring loaded lock is in locked
position.
Then secure the locked handle with the locking pin.