Transportation Of The Product; To Set The Product In Transport Position; To Attach The Product To A Transportation Vehicle; Transportation And Storage - Husqvarna PG 400 Petrol Manual Del Usuario

Problem
The product stops after a while.
The product stops again when you start it.

Transportation of the product

• Close the fuel valve. Refer to
page 12 .
• Safely attach the product during transport to prevent
damages and accidents.
• Put some type of protection on the product during
transportation. The protection keeps natural
elements such as rain and snow away from the
product.
• Always use the lifting eye that is attached to the
product when you lift and move the product.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel tank before you put the product in
storage for a long period of time. Discard the fuel at
an applicable disposal location.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the product in a dry and frost free area.

To set the product in transport position

• To set the product in transport position, refer to
adjust the frame height on page 9 .
To attach the product to a
transportation vehicle
Attach the product during transportation to prevent
accidents and damage to the equipment.
883 - 002 -
Cause
The height and weight adjust-
ment is not correct.
To high load.
Incorrect fuel tank cap. Refer to
different fuel tank caps on page
12 .

Transportation and storage

To start the product on
To
Possible solutions
Make sure that the height and
weight adjustment are correct.
Refer to
height on page 9 and To adjust
the handlebar on page 8 .
Attach more diamond tools or
change to a harder bond.
2
Make sure to the fuel tank cap is
fully tightened when you operate
the product.
Speak to an approved service
center.
1. Attach tie-down straps in the related holes on the
product.
2. Attach and tighten the tie-down straps to the
transportation vehicle.
To adjust the frame
4X
17