To Connect A Dust Extractor; Throttle Control - Husqvarna PG 400 Petrol Manual Del Usuario

2. Put the product into servicing position.
3. Use a hammer to remove the diamond tools.
4. Attach new diamond tools on the tool plate.
883 - 002 -
5. Put the product into operation position.

To connect a dust extractor

When dry grinding, use a Husqvarna dust extractor
Technical data on page 18 .
system. Refer to
Recommended dust extractors are Husqvarna T 4000
Petrol or S 36.
1. Connect the dust extractor to the product.
2. Make sure that the filters in the dust extractor are
clean and not damaged. Monitor the dust during the
operation.

Throttle control

The throttle control has 3 available positions:
• Stop position (A).
• Operation mode position (B).
• Start position/choke position (C).
11