To Prevent A Kickback; To Do Before You Start The Product; Basic Working Techniques - Husqvarna K 7000 Chain Manual Del Usuario

1. Secure the pipe so it does not move or roll during
cutting.
2. Cut section "I" of the pipe.
III
3. Ensure that the cut opens to avoid pinching.
4. Move to side II and cut from section I to bottom of
the pipe.
5. Move to side III and cut the remaining part of the
pipe ending at the bottom.

To prevent a kickback

WARNING: Avoid situations where there is a
risk of kickback. Take care when using your
power cutter and make sure that the
diamond chain is never pinched in the
kickback zone.
WARNING: Be careful when you put the
diamond chain in an existing cut.
WARNING: Make sure that the work piece
cannot move during a cutting operation.
1455 - 003 - 03.03.2020
I
II
WARNING: Only you and proper working
technique can eliminate kickback and its
dangers.
• Always support the work of piece so that the cut can
keep open when cutting through. When the cut is
open there is no kickback. If the cut is closed and
pinches the diamond chain, there is a risk of
kickback.

To do before you start the product

• Read the operator's manual carefully and make sure
that you understand the instructions.
• Do the daily maintenance. Refer to
schedule on page 18 .
• Make sure that the power pack is connected to a
grounded power outlet.
• Make sure that the mains voltage agrees with the
specification on the rating plate on the product.
• Make sure that only approved persons are in the
work area.
• Make sure that you are in a safe and stable position
during operation.
• Always use a power pack with RCD. Refer to the
operator's manual for the power pack.
• Make sure that the water connector is connected
with a water supply. Refer to
supply on page 15 .

Basic working techniques

WARNING: Do not pull the product to one
side. The diamond chain can break and
cause injury to the operator or bystanders.
WARNING: Do not grind with the side of the
guide bar and diamond chain. The guide bar
and the diamond chain can break and cause
injury to the operator or bystanders. Only
use the cutting section.
WARNING: Make sure that the diamond
chain is installed correctly and does not
show signs of damage.
WARNING: Do not use the product to wood
or cut plastic material.
Maintenance
To connect the water
13