Maintenance; Maintenance Schedule - Husqvarna K 7000 Chain Manual Del Usuario

Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional

Maintenance schedule

Maintenance

Clean the external parts of the product.
Do a general inspection.
Lubricate the diamond chain and the guide bar to prevent corrosion.
Do a check of the water system.
Make sure that the power trigger and the power trigger lockout operate correctly
from a safety point of view.
Do a check of the hand guard, rear hand guard, transmission cover and spray
guard.
Do a check of the guide bar and the diamond chain.
Do a check of the vibration damping system.
Do a check of the keyway and the rim sprocket when you replace the diamond
chain.
To clean externally
CAUTION: Do not use a high-pressure
washer to clean the product.
• Flush the product externally with clean water after
each day of operation. If it is necessary, use a brush.
To do a general inspection
• Make sure that the nuts and screws on the product
are tightened.
• Make sure that the cables on the product are not in a
position where they can become damaged.
• Examine the electrical parts for damage. Do not
operate a product that has damaged electrical parts.
18
Maintenance
repairs and servicing is available. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
For spare parts, speak to your Husqvarna dealer or
service agent.
To do a check of the keyway and rim sprocket
• Examine the keyway and the rim sprocket for wear.
If it is necessary, replace them.
To replace the rim sprocket
1. Loosen the bar nuts and remove the transmission
cover.
Daily
X
X
X
X
X
X
X
X
WARNING: Use protective gloves to prevent
injury from the diamond chain.
1455 - 003 - 03.03.2020
Weekly or each
40 h
X