To Install The Guide Bar And The Diamond Chain - Husqvarna K 7000 Chain Manual Del Usuario

2. Remove the center screw (A) and the nut washer (B)
with the combination wrench.
3. Remove the rim sprocket (C).
4. Install the new rim sprocket (0.444") on the keyway
with 7 splines (D) on the product.
5. Install the nut washer, the center screw and the
transmission cover.
6. Install the transmission cover and tighten the bar
nuts by hand. Turn the chain tensioning screw
clockwise to tighten the diamond chain.
1455 - 003 - 03.03.2020
7. To get the correct tension of the diamond chain, hold
up the guide bar tip. Then tighten the bar nuts with
the combination wrench. Make sure that you can
easily pull the diamond chain around the guide bar
by hand.

To install the guide bar and the diamond chain

WARNING: Use protective gloves to prevent
injury from the diamond chain.
1. Loosen the bar nuts and remove the transmission
cover.
2. Remove the center screw and the nut washer with
the combination wrench.
3. Put the diamond chain on the guide bar. Start on the
top side of the guide bar (A).
4. Put the diamond chain on the rim sprocket (B).
19