Hand Guard; To Examine The Hand Guard; Transmission Cover, Spray Guard And Rear Handle Guard - Husqvarna K 7000 Chain Manual Del Usuario

2. Push the power trigger lockout and make sure that it
goes back when you release it.
3. Make sure that the power trigger and power trigger
lockout move freely and that the return springs
operate correctly.
4. Start the product and apply full speed.
1455 - 003 - 03.03.2020
5. Release the power control and make sure that the
diamond chain stops in less than 10 seconds and
stays stationary.

Hand guard

WARNING: Make sure that the hand guard
is correctly installed before you start the
product. Do not use the product if the hand
guard is missing, defective or has cracks.
The hand guard prevents hand injury from the diamond
chain during operation.

To examine the hand guard

WARNING: A damaged hand guard can
cause injury.
1. Make sure that the hand guard is attached correctly
and does not show signs of damage.
2. Make sure that the hand guard has no cracks or is
damaged.
3. Replace the hand guard if it is damaged.
Transmission cover, spray guard and rear
handle guard
WARNING: Make sure that the transmission
cover, the spray guard and the rear handle
guard are correctly installed before you start
the product. Do not use the product if they
are missing, defective or have cracks.
9