To Operate The Product, R112C5 - Husqvarna R112C Manual De Usuario

7. When the engine starts, immediately release the
ignition key to neutral position.
Note: Do not run the starter for more than 5 seconds
at a time. If the engine does not start, wait 15
seconds before you try again. Then if the engine
does not start, wait 1 minute before you try again.
8. Let the engine run at half throttle (B) for 3-5 minutes
before you apply heavy load.
9. Set the engine speed with the throttle control.
Note: To engage the blades when the engine is at full
speed causes strain on the drive belts. Do not apply full
throttle until the cutting deck has been lowered to the
mow position.
To operate the product, R112C, R115C
1. Select cutting height (1–5) with the cutting height
lever.
2. Start the engine.
3. Press the parking brake pedal down and then
release it to disengage the parking brake.
831 - 001 - 15.06.2018
4. Carefully press down one of the speed pedals. The
speed increases the more the pedal is pressed
down. Use pedal (1) to move forward, and pedal (2)
to reverse.
5. Release the speed pedal to engage the brakes.
6. Lower the cutting deck.

To operate the product, R112C5

CAUTION: To prevent damage to the
gearbox, always stop the product and
disengage the engine before you change
gears.
1. Select cutting height (1–5) with the cutting height
lever.
2. Start the engine.
3. Press the parking brake pedal down and then
release it to disengage the parking brake.
1
2
15