Troubleshooting Schedule; Troubleshooting - Husqvarna R112C Manual De Usuario

Troubleshooting schedule

If you cannot find a solution to your problems in this
owner's manual, speak to your Husqvarna service
agent.
Problem
The starter motor does not turn
the engine over
The engine does not start when
the start motor turns the engine
over
The engine does not run smooth-
ly
The engine apparently has no
power
The battery does not charge
26

Troubleshooting

Cause
The parking brake is not applied. See
page 16 .
The lift lever for the cutting deck is in mow position. See
ting deck on page 13 .
The main fuse is blown. See
The ignition lock is defective.
The connection between the cable and the battery is bad. See
battery on page 22 .
The battery is too weak. See
The starter motor is defective.
There is no fuel in the fuel tank. See
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburettor or fuel line.
The spark plug is defective.
The carburettor is incorrectly set.
The air filter is clogged. See
20 .
The fuel tank vent is blocked.
There is dirt in the carburetor or fuel line.
The throttle control is set to choke position or the throttle wire is incorrectly ad-
justed
The air filter is clogged. See
20 .
The spark plug is defective.
There is dirt in the carburetor or fuel line.
The throttle control is set to choke position or the throttle wire is incorrectly ad-
justed
The battery is defective. See
The connection at the cable connectors on the battery terminals is bad. See
charge the battery on page 22 .
To apply and release the parking brake on
To replace the main fuse on page 22 .
To charge the battery on page 22 .
To fill fuel on page 13 .
To replace the air filter, R112C, R112C5 on page
To replace the air filter, R112C, R112C5 on page
Battery safety on page 10 .
To lift and lower the cut-
To charge the
To
831 - 001 - 15.06.2018