To Operate The Product - Husqvarna R 316TX Manual De Usuario

6. When the engine starts, immediately release the
ignition key to neutral position.
CAUTION:
more than 5 seconds at a time. If the
engine does not start, wait 15 seconds
before you try again.
7. Turn the key to the lights position to make the
headlights and the rear lights come on.
8. Push the choke control gradually forward to the end
position.
9. Let the engine run at half throttle for 3-5 minutes
before you apply heavy load.
10. Pull the throttle control rearward to full throttle
position.
844 - 009 - 25.11.2021
Do not run the starter for
CAUTION:
the engine is at full speed causes strain on
the drive belts. Do not apply full throttle until
the cutting deck is lowered to the mow
position.

To operate the product

1. Start the engine.
2. Press the parking brake pedal down and then
release it to release the parking brake.
3. Carefully press down one of the speed pedals. The
speed increases the more the pedal is pressed
down. Use pedal (1) to move forward, and pedal (2)
to reverse.
4. Release the pedal to brake.
5. Select cutting height (1–10) with the cutting height
lever.
To engage the blades when
1
2
17