To Start The Engine; To Operate The Product - Husqvarna P 520DX Manual De Usuario

2. Pull the PTO button to engage the drive on the
cutting deck blades.

To start the engine

1. Push down and turn the main switch to the ON
position.
2. Apply the parking brake.
3. Push the PTO button to disengage the operation of
the cutting deck.
4. Move the throttle control to the middle position.
5. Turn the ignition key to the ON position. Wait for the
display lights to come on.
6. Turn the ignition key to the arrow position. Hold it in
this position until the engine starts.
22
7. When the engine starts, immediately release the
ignition key to the ON position, to prevent damage to
the starter.
ON
CAUTION:
more than 6 seconds at a time. If the
engine does not start, wait 15 seconds
before you try again.
8. Let the engine run at ½ throttle for 3-5 minutes
before you apply a heavy load.
9. Push the throttle control to full throttle position.
CAUTION:
the engine is at full speed causes strain on
the drive belts and the clutch. Do not apply
full throttle until the cutting deck is lowered
to the mow position.

To operate the product

1. Start the engine.
2. Release the parking brake.
Do not run the starter for
To engage the blades when
1593 - 002 - 22.12.2020