To Lower The Cutting Deck To The Mow Position; To Start The Engine; To Operate The Product - Husqvarna P 520D Manual De Usuario

To lower the cutting deck to the
mow position
1. Move the lift lever for hydraulic lift forward to lower
the cutting deck to mow position.
2. Pull the PTO button out to engage the drive on the
cutting deck blades.

To start the engine

1. Make sure that the bypass valves are closed. Refer
To release and apply the hydraulic pressure on
to
page 118 .
2. Apply the parking brake.
3. Push in the PTO button to disengage the drive on
the cutting deck.
4. Move the throttle control to the middle position.
740 - 002 -
5. Turn the ignition key to the start position (A).
6. When the engine starts, immediately release the
ignition key to neutral position (B).
CAUTION: Do not run the starter for
more than 5 seconds at a time. If the
engine does not start, wait 15 seconds
before you try again.
7. Push the throttle control gradually forward to the end
position.
8. Let the engine run at half throttle for 3-5 minutes
before you apply a heavy load.
9. Push the throttle control to full throttle position.
CAUTION: To engage the blades when the
engine is at full speed causes strain on the
drive belts. Do not apply full throttle until the
cutting deck is lowered to the mow position.

To operate the product

1. Start the engine.
2. Release the parking brake.
B
A
119