Before You Begin; Tools You Will Need - Sears Kenmore 1101 Guía De Uso Y Cuidado

BEFORE YOU BEGIN
Read these instructions completely and carefully,
IMPORTANT--Save these instructions for the local
electrical inspector's use_
IMPORTANT---Observe all governing codes and
ordinances.
NOTE TO CONSUMER:
Keep this Use and Care Guide for future use,
NOTE TO INSTALLER:
Leave these instructions with the appliance after
installation is completed,
NOTE: This appliance must be properly grounded.
1. Prepare the Opening
Allow 1_,_ " spacing from the range to adjacent vertical
wails above cooktop surface,
Allow 30" minimum clearance between surface units
and bottom of unprotected wood or metal top cabinet,
and 15" minimum between countertop and adjacent
cabinet bottom
EXCEPTION: Installation of a listed microwave
oven or cooking appliance over the cooktop shall
conform to the installation instructions packed
with that appliance.
If cabinet storage is installed, reduce risk by installing
a range hood that projects horizontally a min_ of 5"
beyond the bottom of the cabinets, Make sure the wall
covering, countertops and cabinets around the range
can withstand heat generated by the range, oven or
cooktep up to 200°F,
TOOLS YOU WILL NEED
• Large blade screwdriver
= 1/4" hex head nutdriver
=Channel lock pliers
.1_" open end or adjustable wrench
o Tape measure
I -<(---_-=-_-- Not lass then the
width of the range
• Hood
ELECTRICAL REQUIREMENTS
CAUTION, FOR PERSONAL SAFETY: DO NOT
USE AN EXTENSION CORD WITH THIS APPLIANCE,
REMOVE HOUSE FUSE OR OPEN CIRCUIT BREAKER
BEFORE BEGINNING INSTALLATION
This appliance must be supplied with the proper voltage
and frequency, and connected to an individual, properly
grounded branch circuit, protected by a circuit breaker or
time delay fuse, as noted on the rating plate.
Wiring must conform to National Electric Codes.
If the eiectdc service provided does not meet the
above specifications, have a licensed electrician
install an approved outlet,
Because range terminals are not accessible after range is
in position, flexible service conduit or cord must be used°
Install the
outlet box on
either side of
the CL
Locate the outlet
box within either
shaded area
t5