Troubleshooting - Franklin Chef FIM70 Manual Del Usuario

TROUBLESHOOTING
Before ( tlling fi r Service
If the unit appears to be malfunctioning, read through the OPERATION section of this
manual first. If the problem persists, check the TROUBLESHOOTING GUIDE below
and on the following page. The problem could be something very simple which can be
solved without a service call.
Troubleshooting Guide
Problem
The machine
doesn't operate.
The water doesn't
feed in after the ice
maker starts.
Machine makes
ice, but ice storage
bin does not fill up
with ice.
Possible Cause
The ice maker is unplugged.
The fuse is blown.
The ice maker power
switch is OFF.
The ice storage bin is full of
ice.
The water supply tap is
turned off.
The water supply line is not
connected properly.
The bin should fill up and
the machine shut off in
9-14 hours. If not, the
condenser may be dirty.
The bin drain may be
partially restricted.
The airflow to the ice
maker may be obstructed.
The ambient temperature
and water temperature are
high, or machine is near
some heat source.
Probable Correction
Plug the ice maker in.
Replace fuse. If it happens again, call
for service to check for a short circuit
in the ice maker.
Turn the ice maker power switch ON.
Remove some ice; make sure the
ice-full sensor is free of ice.
Turn on the water supply tap.
Reconnect the water supply line.
Clean the condenser.
Clean out the drain; check the
installation.
Check the installation.
Check the installation.
26