Squeegee lifting
Lift the squeegee as indicated below:
1.
Grasp the handlebar (2), lower it until the rear wheel (7)
touches the floor (A, Fig. 3) then engage the squeegee in
lifted position (B)
MACHINE OPERATION (SCRUBBING/DRYING)
1.
Start the machine as shown in the previous paragraph.
2.
While keeping both hands on the handlebar (2), move the machine and start scrubbing/drying the floor.
3.
If necessary, adjust the solution quantity by using the push-button (67).
CAUTION!
To avoid damaging the floor surface, do not use the brush without the solution and, when the machine is not
operating, stop the brush/pad-holder by releasing the levers (70).
CAUTION!
Before lifting the brush/pad, turn it off by releasing the levers (70).
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Advance suggests to go near the walls with the right side
of the machine as shown in figure 4.
CAUTION!
In case of brush/pad-holder motor overload, due to foreign bodies which prevent them from turning, or to
excessively aggressive floors/brushes, the safety system stops the brush/pad-holder after about one minute of
continuous overload.
The overload is shown by the three battery LEDs (68) flashing simultaneously.
To start scrubbing again after a brush/pad-holder stop due to overload, stop the machine by turning the knob
(62) to "0". Restart the machine by turning the knob to one of the working programs.
A
A
INSTRUCTION FOR USE
Figure 4
9099626000 - SC400
click
A
B
Figure 3
B
ENGLISH
P100626
P100627
15