Machine Operation (Scrubbing/Drying) - Advance Adfinity 17ST Instrucciones De Uso

MACHINE OPERATION (SCRUBBING/DRYING)

1. Start the machine as shown in the previous paragraph.
2. If necessary, press the washing water fl ow control switches (82) as necessary, depending on the type of cleaning to be carried
out.
3. If necessary, stop the machine and adjust the squeegee balancing handwheel (27).
4. If necessary, stop the machine and turn the adjusting handwheel (28); when turning it clockwise or counter-clockwise the
machine forward speed can be adjusted.
5. (Only for Adfi nity™ 17ST - 20ST): If necessary, stop the machine and turn the forward speed adjusting handwheel (29) as
shown below:
• Turn it counter-clockwise to increase the forward speed;
• Turn it clockwise to decrease the forward speed.
NOTE
For correct scrubbing/drying of fl oors at the sides of the walls, Advance suggests to go near the walls with the right side
of the machine as shown in fi gure 3.
CAUTION!
To avoid any damage to the fl oor surface, turn off the brush/pad-holder when the machine stops in one place,
especially when the extra pressure function is on.
Adjustment of the detergent concentration in the solution
(For Adfi nity™ X20R)
The system used to mix the detergent with the washing water can be activated by pressing the detergent fl ow control switch (A, Fig.
4): when the led (B) is on, the detergent is added to the washing water.
The display (C) shows the detergent concentration level (1 to 6) in the solution: for the related percentage values refer to the table
(D).
NOTE
The detergent concentration in the solution dispensed from the system always corresponds to level 1. In order to
temporarily obtain a stronger concentration, press the EcoFlex™ switch or disable the EcoFlex™ system (see the
relevant paragraph).
A
Adfi nity™ 17ST - 20ST - X20R
INSTRUCTION FOR USE
Figure 3
9096912000(4)2010-11
ENGLISH
B
15
P100106A