Safety Notes For Maintenance And Troubleshooting On The Minifil Device - Kemper MiniFil Instrucciones De Uso

2.5 Safety notes for maintenance and troubleshooting on the
MiniFil device
All the activities within the maintenance and troubleshooting must be performed
using appropriate personal protective equipment. Before starting the maintenance
works, the unit must be cleaned. This can be achieved using an industrial vacuum
cleaner of dust class "H".
Preparation, maintenance and repair works, as well as error detection can be
performed only in the de-energized state of the MiniFil device.
Bolted joints, loosened during maintenance and repair works, shall always be
tightened! If specified, the relevant bolts must be tightened with a torque wrench.
At the beginning of maintenance/repair/care it is particularly necessary to remove
impurities from connections and bolted joints.
CAUTION
Skin contact with the smoke originating from cutting, etc. may
result in irritation in sensitive individuals!
Repair and maintenance works on the MiniFil device can only be
performed by trained and authorized professional personnel in
compliance with applicable safety instructions and accident
prevention regulations!
Risk of severe damage to the respiratory organs and respiratory
system!
Use protective clothing, gloves and a breathing apparatus with a
fan to prevent contact with dust and its inhalation!
Prevent the release of hazardous dusts during repairs and
maintenance to avoid injury to persons not involved in the
process.
- 42 –
Technical changes and errors reserved.
KEMPER MiniFil Instruction Manual - EN