Installing The Battery - Tennant S8 Manual De Uso Y Recambios

- To ensure that the traction lever works properly make sure
the lever cable is positioned as shown before replacing the
rear shroud. (Fig.2/C)
Fig.2/C
2.1.3 -Mounting the Bumper Wheels
- Mount the two mounting wheels as shown and secure with snap
ring (Fig.2/D)
Fig.2/D

2.1.4 -Installing the Battery

FOR SAFETY: Wear protective gloves and eye protection when
handling battery and battery cables. Avoid contact with battery
acid.
Battery Specifications:
One 12 volt deep cycle battery.
Maximum battery dimensions: 18 cm (7.00 in) P x 32 cm (12.50 in)
L x 24 cm (9.38 in ) H.
IMPORTANT: The on-board battery charger setting MUST be re-
configured if changing to a different battery type, WET (lead acid)
or SEALED (Gel) battery. See 5.3 CHARGER SETTINGS.
To Install Battery:
1. Remove key from machine.
2. Open the front hood to access the battery compartment.
3. Carefully position the battery into the battery tray with battery
post towards front of machine and connect cables to battery, RED
to POSITIVE (+) and BLACK to NEGATIVE (-) (Fig 2/E).
Fig.2/E
4. Secure battery with strap.
5. Charge battery. See 5.2.1. BATTERY RECHARGE.
- 7 -